Zontes ZT350T-D, Maintenance Manual, Page: 127 / 152

127 / 152
Change the direction of the handle
Caution:
●When removing the disc brake oil cup, it must be vertically
upward to prevent air from entering the brake pipeline.
●When disassembling and assembling the handle switch, pay
attention to adjusting the internal wiring harness of the
switch to avoid damage to the wire skin caused by the shell
or bolt column.
1. Remove the direction of the handle
a. Hold the middle cover in the direction with your hands,
and pull out the middle cover in the direction of the arrow.
b. Use a cross screw to remove the two self-tapping ST3.9
×
12 screws at the lower cover, and use a straight screw to
pry off the buckles at① and②.
c. Use a single word batch to pick up the 3 buckles③, ④,
⑤ of the upper cover from the hole of the middle cover in
the direction, grasp the direction near the side of the seat
cushion, and remove the upper cover in the direction of the
arrow. The direction of the upper cover.
2. Remove the components
a. Use 5# inner hexagon to remove 4 M6×30 bolts
⑵
, and
remove the left auxiliary handle switch, the rear disc brake
main pump, the right auxiliary handle switch, and the front
disc brake main pump.
b. Use 4# inner hexagon to remove the M6×14 bolt
⑶
;
then use 6# inner hexagon to remove 4 M8×35 bolts
⑷
,
remove 2 pressure blocks, and take out the direction handle
assembly.
c. Use 5# inner hexagon to remove the bolts (5a) and (5b)
that come with the right-hand handle under the switch, and
then use the cross-batch to remove the bolts (5c), and
separate the upper and lower parts of the right-hand handle.
d. Remove the bolts (6a) and (6b) under the left-hand
handle switch with a 5# inner hexagon, and then remove the
bolts (6c) with a cross-batch, and separate the upper and
lower parts of the left-hand switch.