Zontes ZT310M 2022, Maintenance Manual

Page: 28 / 88

1. Remove the guide bar as shown in the figure.
Chenck
1. Check whether the guide bar is excessively worn or damaged.
Guide bar installation
1. Install the guide bar as shown in the figure. (Note: After the guide bar is installed in place, the raised point of the
guide bar is lower than the joint surface of the cylinder block and cylinder head.)
Eight, Tension bar
Before disassembling the tension bar, the following parts need to be disassembled.
· Tensioner.
(Refer to ZT310T-M Engine Maintenance Manual-Cylinder Head Cover, Cylinder Head-Tensioner for
disassembly and assembly)
·The cylinder head cover sub-parts. (For disassembly and assembly refer to ZT310T-M Engine Maintenance
Manual-Cylinder Head Cover, Cylinder Head-Cylinder Head Cover)
·Cylinder head sub-assembly. (Refer to ZT310T-M Engine Maintenance Manual-Cylinder Head Cover, Cylinder
Head-Cylinder Head for disassembly and assembly)
·Cylinder piston sub-assembly.
(Refer to ZT310T-M Engine Maintenance Manual-Cylinder and Piston for
disassembly and assembly)
·Right crankcase cover sub-assembly. ( Refer to ZT310T-M engine maintenance manual for disassembly and
assembly-right crankcase cover, magneto-right crankcase cover, magneto stator)
· Magneto rotor sub-components. ( Refer to ZT310T-M engine maintenance manual for disassembly and
assembly-right crankcase cover, magneto-magneto rotor)
·Electric start gear. ( Refer to ZT310T-M engine maintenance manual for disassembly and assembly-right
crankcase cover, magneto-magneto rotor)
Guide bar