Zontes ZT125-M 2022, Maintenance Manual

Page: 216 / 218

216
/
218
d. Remove the oil tank cover; Press the cushion bracket
with one hand and take out the middle of the tank cover
plate with the other hand.
Caution: When taking out the middle part of the tank
cover plate, it is necessary to pay attention to the wiring
harness of the tank lock, so as not to get stuck and avoid
pulling the wiring harness of the tank lock; to prevent dirt
matters from entering the tank, immediately screw the tank
cover back to the tank after removing the middle cover.
e. Remove the fuel tank lock after breaking the clips that
fix the fuel tank lock to both sides. Pay attention to the
strength when opening the clips to avoid breaking.
f. Use needle nose pliers to remove the circlip and pull out
the rotating shaft. Remove the torsion spring and damper.
Pay attention to the position of the torsion spring when
installing.
g. After removing the ST4.2×12 self-tapping screws with
a 5# inner hexagon, separate the outer cover and the outer
cover bracket. Note that there is a buckle on the head of the
cover that is inserted into the cover bracket.
Disassembly the left and right storage
boxes
a. Press the switch indicated by the small arrow to open
the front right storage box; Use 4# inner hexagon to remove
2 M6x14 bolts and a M6x16 bolt. Remove 1 nail of the front
right storage box with the 4# inner hexagon, finally remove
the front right storage box.
b. Use needle nose pliers to remove the circlip and pull out
the rotating shaft. Remove the torsion spring and damper.
Pay attention to the position of the torsion spring when
installing.
c. Remove 3 M6×14 shoulder bolts with 4# inner hexagon,
and separate the inner and outer covers. Remove the 3-piece
cleat nuts from the outer cover. The foam is attached to the
inner lid with double-sided tape.