ZOLL X Series, Operator'S Manual

Page: 70 / 344

Chapter 3 Monitoring Overview
3-6 www.zoll.com 9650-001355-01 Rev. M
Configuring the Waveform Display
You can display up to four waveform traces on the Waveform Display window. The first
waveform trace always uses an ECG lead as its source (such as
Pads
or Leads
l
,
ll
, or
lll
, and so
on. The default is Pads ). If Pads are not connected, the unit can be configured to
automatically default to another ECG lead for the first trace. As you insert the remaining three
traces, you can specify that the traces use an ECG lead as the waveform source, or that the trace
derive its waveform from other available monitoring functions (such as
Resp
,
CO2
,
SpO2
or
IBP channels P1 , P2 , or P3 ).
If configured, the unit can display four ECG traces on startup, when no other monitoring
devices are attached.
The X Series unit can also cascade a trace onto the adjoining trace area to double the duration
of the trace display.
On the Waveform Display window, to insert a new trace ( Insert ) or cascade ( Cascade ) a
displayed trace, highlight and select the trace label above the trace. In the following example,
the unit is configured to cascade the ECG Lead l trace:
Note: The X Series unit automatically inserts a new waveform when you turn on a parameter
(CO
2
) or a new sensor signal is present (SPO
2
, IBP). The X Series unit automatically
removes a waveform when you turn off a parameter or remove a sensor and the unit
displays the resulting equipment alert.
06/06/2011 12:34:56
Adult
00:17:43
I, II,
III...
12
CO
2
R
SYNC
1 cm/mV II
HR
bpm
80
121
79
(96)
NIBP
mmHg
38
12 BR
CO2
mmHg
SpO2
%
97
T1
ºF
98.6
Pads
III
aVL
aVF
V
Insert
Source
II
aVR
I
Cascade