ZOLL Propaq MD, Service Manual

Page: 40 / 142

C
HAPTER
1 M
AINTENANCE
T
ESTS
34 9650-0807-01 Rev. C
17.0 EtCO
2
Calibration Check
Equipment
5% CO
2
calibration gas cylinder with CO
2
sample line (kit available from Scott Medical
Products, PN 4653ORF-BD)
Note: If you have previously run the CO2 Calibration procedure, start at step 3.
Do This... Observe This... Pass/Fail
17.1 On the
Propaq
unit, select
Supervisor > Service > Diagnostic > CO
2
>
Calibration to enter the CO
2
Calibration
control panel.
17.2 Connect the
Propaq
unit to the 5% CO
2
calibration gas cylinder using the sample
line included with the calibration kit.
17.3 From the CO
2
Calibration control panel,
select Verify Calibration .
17.4 Activate the calibration gas flow by
pressing the top valve on the calibration gas
canister.
17.5 Continue to apply the calibration gas until
the status in the CO
2
Calibration control
panel displays: CALIBRATION GAS CAN
BE REMOVED .
o o
17.6 Verify that the unit displays:
VERIFICATION DONE - OK.
o o
17.7 Verify that the measured gas reading is
between 4.8 and 5.2 (Vol%). o o
17.8 Exit out of calibration by pressing the Back
arrow key ( ) three times or pressing the
Display/Home button ( ).