ZOLL Propaq MD, Service Manual

Page: 23 / 142

Maintenance Tests
9650-0807-01 Rev. C ZOLL Propaq MD Service Manual 17
5.0 Heart Rate Alarm Test
Equipment
Fluke Impulse 7000DP Analyzer
Do this... Observe this... Pass/Fail
5.1 Press the Leads quick access key
( )
on the Propaq unit and select
lead
II
.
II
displays next to the Leads quick
access key.
o o
5.2 On the Propaq unit:
•
Press the More quick
access key ( ) key to
access the second set of
quick access keys.
•
Press the Alarm quick
access key ( ).
•
Press the Limits softkey.
The Alarm Settings menu displays. o o
5.3 On the Propaq unit, select HR/PR
Alarm in the Alarm Settings menu
and use the navigation keys to do
the following:
•
Set the Upper Limit Enable
to ON.
•
Set the Lower Limit
Enable to ON.
•
Set the Lower limit to 35.
•
Set the Upper limit to 150.
Use the navigation keys to exit the
Alarm Settings menu.
5.4 On the Propaq unit, press the Alarm
Cancel quick access key ( ).
The red alarm suspension timer
displays at the top of the screen next
to the message area.
5.5 Remove a lead wire from the ECG
simulator
.
T
he ECG LEAD FAULT message
displays.
o o
5.6
On the Propaq unit, press .
The Alarm Suspend key flashes
.
5.7 Reattach ECG Lead wire to
ECG
simulator
.
The ECG LEAD FAULT message no
longer displays.
o o
5.8 Set simulator to 30 BPM or lower.
Heart Rate Value is highlighted and
the alarm tone sounds. The
HR/PR
LOW ALARM message displays.
5.9
On the Propaq unit, press .
The Alarm Suspend key flashes. The
red alarm suspension timer displays
at the top of the screen next to the
message area.
o o
5.10 Set the simulator to 120 BPM.
5.11 On the Propaq unit, press
.
Alarm is enabled. The alarm suspend
key flashes. The alarm suspension
timer disappears. o o
I, II,
III...