© Copyright 2014 Zoeller
®
Co. All rights reserved.
ATTENTION: READ CAREFULLY BEFORE ATTEMPTING TO INSTALL OR OPERATE YOUR PUMP. PROTECT YOURSELF AND OTHERS BY
OBSERVING ALL SAFETY INFORMATION AND ADDITIONAL INSTRUCTIONS INCLUDED WITH EQUIPMENT. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN FOR FUTURE REFERENCE.
FM2092
1014
Supersedes
0911
INSTALLATION INSTRUCTIONS
These installation instructions are applicable for
Model 311 Portable Utility Pump
“MIGHTY MOVER”
PREINSTALLATION CHECKLIST - ALL INSTALLATIONS
Whenever this file is changed, Tim Moss must be informed. We print copies to be sent
to vendor (Zco Taiwan) for insertion into product. New copies will need to be printed for
production. Also, F & W will need to be notified of changes because they also print this
document (with changes) for their product.
SEE BELOW FOR LIST OF WARNINGS
1. Make sure that the pump is plugged into a properly grounded electrical
receptacle. Use an Underwriters Laboratory listed circuit analyzer to
test for proper installation of the circuit and ground. Any service to
circuits or receptacles should be conducted by a qualified licensed
electrician.
2. Do not remove the ground pin from the plug under any circum-
stances. If the ground pin is damaged, replace the power cord
or plug before use.
3. All electrical installations must conform to the requirements of
the National Electrical Code and all local codes.
4. It is strongly recommended that the unit be plugged into a
G.F.C.I. protected circuit.
5. Disconnect power before servicing the pump or motor.
6.
Do not touch the motor when operating and allow
the motor to cool before touching it afterwards.
7. This pump is designed for water without solids only. It has not
been evaluated for pumping of chemicals.
8 .
Do not use this product to pump flammable or
explosive liquids.
9.
Do not use this product in hazardous environments
or anywhere a spark could potentially ignite explosive
gases.
10. Do not handle this product with wet hands or while standing in
water or on a wet or damp surface.
11. The model 311 is supplied with an automatically resetting thermal
overload device and can restart without warning.
12. Do not submerge the pump or motor in water.
13. Secure the discharge line before starting the pump. An unsecured
hose can whip, possibly causing personal injury or property
damage.
14.
Provide a means of pressure relief if the pump discharge
can be shut off or obstructed. Pumps operating against
a closed discharge can create very hot pumped liquid,
which can cause burns.
15. Do not operate this product while unattended. Do not run dry.
16. Risk of electric shock - These pumps have not been investigated
for use in swimming pool areas.
CAUTION
SEE BELOW FOR LIST OF CAUTIONS
1. Make certain that the power source conforms to the requirements
of the equipment as stated on the product nameplates.
2. Check hoses for weak or worn conditions before use and make
certain that all connections are secure.
3. Periodically inspect the pump for damage and perform routine
maintenance as required.
4. The maximum temperature of the pumped liquid must not exceed
130 deg. F. The minimum allowable temperature is 40 deg. F.
5. Use a screen or strainer on the inlet to prevent solids from
entering the pump.
6. Pumps with the UL mark are certified by UL and tested to UL
standard UL778. Pumps with the CSA mark are certified by
CSA to CSA standard C22.2 No.108. Pumps with the cCSAus
mark are certified by CSA to CSA standard C22.2 No.108 and
UL standard UL778.
REFER TO WARRANTY ON PAGE 2.
Notice to installing contractor: Instructions must remain with installation.
Product information presented
here reflects conditions at time
of publication. Consult factory
regarding discrepancies or
inconsistencies.
MAIL TO: P.O. BOX 16347 • Louisville, KY 40256-0347
SHIP TO: 3649 Cane Run Road • Louisville, KY 40211-1961
TEL: (502) 778-2731 • 1 (800) 928-PUMP • FAX: (502) 774-3624
Visit our web site:
zoellerpumps.com
Register your
Zoeller Pump Company
Product on our website:
http://reg.zoellerpumps.com/
