![background image](http://html1.mh-extra.com/html/zoeller/807/807_installation-instructions-manual_4094781001.webp)
PREINSTALLATION CHECKLIST - ALL INSTALLATIONS
1. Inspect your pump.
Occasionally, products are damaged during shipment. If the unit is damaged, contact your dealer before using.
DO NOT
remove the test plugs in the cover
nor the motor housing.
2. Carefully read the literature
These materials should be retained for future reference.
REFER TO WARRANTY ON PAGE 02.
1.
To reduce the risk of electrical shock, a properly grounded receptacle or control box
must be installed in accordance with the governing codes. Never remove ground pin
from plug.
2. Make certain that the receptacle or control box is within reach of the pump’s power
supply cord. DO NOT USE AN EXTENSION CORD. Extension cords that are too long
a safety hazard if the insulation were to become damaged or the connection end were
to fall into a damp or wet area.
3. Make sure the pump's electrical supply circuit is equipped with fuses or circuit breakers
of proper capacity. A separate branch circuit is recommended, sized according to the
governing electrical codes for the current shown on the pump name plate.
4.
Testing for ground.
As a safety measure, each electrical outlet should be checked
for ground using a circuit analyzer which will indicate if the power, neutral and ground
electrician.
5. FOR YOUR PROTECTION, ALWAYS DISCONNECT PUMP FROM ITS POWER
SOURCE BEFORE HANDLING. If pump is wired direct, de-energize the circuit at the
control box. DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE THE GROUND
PIN. Wear insulated protective shoes and do not stand in water. Pumps equipped
with a grounded plug are designed to help protect against electrical shock. A properly
grounded receptacle or control box must be installed in accordance with governing
codes.
6. Installation and servicing of the pump's electrical circuits and hardware should only be
7. Installation and maintenance of this appliance is not intended for persons (including
children) with reduced physical, sensory or mental capabilities, or lack of experience
or knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
8.
Risk of electrical shock.
Do not remove power supply cord and strain relief or connect
conduit directly to the pump. If the supply cable is damaged, it must be replaced by an
authorized Zoeller Representative.
9. Pump may contain oil which becomes pressurized and hot when operating. Allow 2-1/2
hours after disconnecting before attempting service.
10. Pump is not intended for potable water due to possible contamination by oil contained
in the pump.
11.
Risk of electrical shock.
These pumps have not been investigated for use in swimming
pools and marine areas.
SEE BELOW FOR LIST OF WARNINGS
- 1 -
DO NOT USE FOR PUMPING OILS, GASOLINE OR ANY PETROLEUM BY-PRODUCTS.
Product information presented
here re
fl
e
m
it
t
a
s
n
oi
t i
d
n
o
c
st
c
e
of publication. Consult factory
r
o
s
ei
c
n
a
p
e
r
c
si
d
g
ni
d
r
a
g
e
r
.s
ei
c
n
e
t s
is
n
o
c
ni
Notice to Installer: Instructions must remain with installation.
INSTALLATION INSTRUCTIONS
50/60 Hz
SAFETY INSTRUCTIONS
TO AVOID SERIOUS OR FATAL PERSONAL INJURY OR MAJOR
PROPERTY DAMAGE, READ AND FOLLOW ALL SAFETY
INSTRUCTIONS IN THIS MANUAL AND ON THE PUMP.
THIS MANUAL IS INTENDED TO ASSIST IN THE INSTALLATION AND
OPERATION OF THIS UNIT AND MUST BE KEPT WITH THE PUMP.
THOROUGHLY REVIEW ALL INSTRUCTIONS AND WARNINGS PRIOR
TO PERFORMING ANY WORK ON THIS PUMP.
MAINTAIN ALL SAFETY DECALS.
CAUTION
Warns of hazards that
CAN
cause serious personal
injury, death or major property damage.
Warns of hazards that
CAN
cause personal injury or
property damage.
Warns of electrical shock hazards that
CAN
cause serious
personal injury, death or major property damage.
to an external conductor for protection against electrical
shock in case of a fault, or the terminal of a protective
earth (ground) electrode.
Read operator's manual.
Identifies any terminal which is intended for connection
This is a
SAFETY ALERT SYMBOL.
When you see this symbol on the pump or in the manual
look for one of the following signal words and be alert to
the potential for personal injury or property damage.
© Copyright 2020 Zoeller Co. All rights reserved.
®
ZT0218_ESc
0420
Supersedes
0717
P/N 094294
807 / 2702 / 2712
2722 / 2732 / 2741 / 2742
Visit our web site:
zoellerpumps.com