Page 23 / 47
Edition 3
E
N
G
L
I
S
H
INSPECTION BEFORE USE
IV- INSPECTION BEFORE USE
Check with your distributor /agent that your boat has been pre-inspected and examined in
accordance with the manufacturer’s conditions.
ITEM
CHECK
INFLATABLE TUBE (1)
Pressure (240 mb) + valve plug cover in place
BILGE (1)
Absence of water
12V BATTERY (2)
Charge state normal
BMW i3 HIGH-VOLTAGE BATTERY (1) Charge state 100%
THRUST REVERSER FLAP (1)
Mechanism operating properly
STEERING WHEEL (1)
Mechanism operating properly
COOLING SYSTEM(1)
Pumps operating properly and filter cleaned
Cooling Policy set to Normal if the water temperature is
above 28°C (82°F) other than set it to Early
ELECTRICITY (1)
Circuit b Navigation light + fan + bilge pump tested
PROPULSION (2)
No foreign matter in the maintenance hatch
EXTINGUISHER (2)
State + compliance
(1)
Before each outing
(2)
Regular servicing
IV-1 INFLATABLE TUBE
Check that the inflatable tube
is correctly inflated. See in the “
INFLATING THE INFLATABLE TUBE
”
section of this manual.
IV-2 BILGE
If any dampness or water in the bilge, drain by operating the bilge pump. Remove any traces of
dampness with dry, clean cloths.
Although the Boat is provided with automatic hull draining system which drains water from the engine
compartment during boat use. Some water always remains.
IV-3 12V BATTERY
Check that the charge state of the 12V battery. It has to be at least 11V.
IV-4 BMW i3 HIGH-VOLTAGE BATTERY
Check that the charge state of the high-voltage battery is 100%.
NOTE
: see Torqeedo’s user Manual, chapter
Charging the high-voltage batteries
.