ZMC408SCAN Motion Controller Hardware Manual V1.5
3.3.2.
Basic Usage Method
(1)
Please follow the above wiring instructions to wiring correctly.
(2)
After powered on, please use any one interface among the three interfaces ETHERNET,
RS232 and RS485 to connect to ZDevelop.
(3)
Open or close output port directly through “OP” command, also, it can be opened or
closed through “ZDevelop/View/Op”. Please refer to “ZBasic” fo
r details.
(4)
The PWM function, set the
frequency and duty cycle through “PWM_FREQ” and
“PWM_DUTY”. Please refer to ZBasic for details.
(5)
Hardware comparison output can be set and opened through “HW_PSWITCH2”.
Please refer to ZBasic for details.
