XPLC3264E Controller Manual
2
Chapter One Introduction
ZMC is short for ZMotion motion controller. ZMotion motion
controller can be used in various occasions where offline or online
operation is required.
ZMC supports up to 12-axis linear interpolation, arbitrary
circular interpolation, spatial circular, helical interpolation,
electronic cam, electronic gear, synchronous following, virtual axis
setting, etc.
ZMC supports multi-task running at the same time, at
the same time it can be directly simulated on the PC.
XPLC is a product of ZMC motion controller
integrated ladder diagram and configuration software.
1.1
Connection configuration
Typical connection configuration diagram
The XPLC motion controller supports Ethernet, USB, CAN, 485 and
other communication interfaces. Each expansion module can be
connected through the CAN bus to expand the number of input / output
points or motion axes (120 ohm resistors need to be connected in
parallel at both ends of the CAN bus).
XPLC motion controller supports U disk to save or read data.
