ECI3828 Network Motion Control Card User Manual V1.5
connect carefully.
If the speed can meet the requirements, use low-speed differential pulse port
preferentially. When high-speed differential pulse interface is used, controller internal
digital ground must be connected to drive high-speed pulse reference ground.
Please use STP, especially there is bad environment, make sure shield layer is fully
grounded.
Some servo drives are not isolated by optocoupler. At this time, the GND must be
connected to the GND of the driver. Most of the drive encoders are not isolated by
optocoupler. When connecting the encoder, GND must be connected.
3.9.2.
Basic Usage Method
(1)
Please follow the above wiring instructions to wiring correctly.
(2)
After power on, please use ETHERNET or RS232 (default parameter, it can be
connected directly) to connect to ZDevelop.
(3)
Set axis parameters, such as, ATYPE, UNITS, SPEED, ACCEL, FWD_IN, REV_IN, etc.
(4)
There are many parameters related to pulse axis, they can be set and checked
through relative instructions, please see “axis parameter and axis status” of “ZBasic”,
or see “ZDevelop/View/Axis parameter”.
Summary of Contents for ECI3828
Page 1: ......
