Maintenance
35
Place toolhead in conve-
nient position for remov-
ing worktable.
Slide the table back-
wards.
Disconnect the table
plug.
Pull the worktable for-
ward.
Pull the lever placed on
the left to unlock the
heated table.
Lift the table with a
little bit of strength up to
disconnect it from the
carriage magnets.
10.2 Changing worktable
Take the CNC table. No-
tice the magnets under
the table are on the prop-
er side.
Place the worktable on
the carriage, magnets
will clip it on.
Pull the lever back to
block the table
NOTE:
The user can move the toolhead manually by disabling the motors by:
• pressing the reset button,
• powering down the machine,
• parking the toolhead in the "Change toolhead" section,
• waiting 1 minute for the standby mode.
