Product Manual - ZMORPH i500
8
Health and safety
2.3 Occupational hygiene
▪ Special care must be taken when carrying out a repair, maintenance or servicing operations. The user is
exposed to high temperatures. Protective gloves are recommended.
▪ Even with the HEPA and carbon filtration system it is recommended that a dedicated space with
adequate ventilation is provided for the device. It is not recommended that you stay in the same room
where the device is working continuously.
▪ The noise emitted when working with 3D printing toolheads is 45 dB but continuous presence in one
room can cause discomfort to the user.
▪ Place the device on a stable and flat surface.
▪ Do not use materials that may damage the device or that are not authorized for use with the
toolheads.
▪ When using Zmorph i500, ensure all necessary health and safety measures as described in this manual
and separate regulations.
▪ Handle the sharp accessories and tools included with the kit with special caution.
2.4 Electrical safety and risk
Zmorph i500 devices have been tested to comply with the Low Voltage Directive. In order to ensure max-
imum safety of use, including protection against short circuits, overloads, overvoltages and overheating of
the product, the following provisions must be observed:
▪ Do not modify the machine, toolhead and its electronic components.
▪ Do not use electronic substitutes other than those recommended by the manufacturer.
▪ Replacement of electronic components should be done in accordance with the recommendations and
instructions provided by the manufacturer.
▪ Before connecting the 3D printer to the power outlet, make sure that the voltage required by the
device corresponds to the voltage available from the power source. For power supply information, refer
to the nameplate on the rear of the device.
▪ Avoid overloading the power outlet to which the 3D printer is connected.
▪ The device must be properly grounded. Always make sure that the grounding is in accordance with
local and national regulations.
▪ Use only the original power cord or one authorized by the manufacturer. It must not be destroyed, cut
or repaired. Replace a damaged cable immediately with a new one.
▪ Perform repair and maintenance work on the device when it is disconnected from the power supply.
▪ Do not expose the device to moisture or modify electronic components (e.g. soldering).
