Product Manual - ZMORPH FAB
68
12.7 Autocalibration
Single Extruder Toolhead 1.75
3D printing workflow
Before performing the automatic calibration make sure the worktable is clean and prepared.
During the automatic calibration process the printer is heating up.
Choose ‘CALIBRATE’.
Choose ‘
AUTO 3-POINT
’. Wait
for the machine to heat up
and finish the probing.
To ensure the best calibration
result print calibration
pattern. Choose ‘START’.
LOAD
FILAMENT
CHANGE
TOOL
CALIBRATE
3D PRINTING
BACK
MORE
CALIBRATION
AUTO
3-POINT
BACK
MORE
MANUAL
CALIBRATION
NEW JOB
MAINTENANCE
In the last calibration step the machine
will print five lines as a final touch
SKIP
START
CALIBRATION
NOTE
Connect the LEFT cable to
the LEFT frame socket and
RIGHT cable to the RIGHT
frame socket.
Connect the extruder ‘A’ cable
to the ‘A’ plug and the ‘B’
cable to the ‘B’ plug on the X
carriage.
Choose ‘MAINTENANCE’.
