Product Manual - ZMORPH FAB
30
Setting up Zmorph Fab
9.4 Assembling the HEPA filter
A filtration system can be mounted on the Zmorph Fab machine.
Find the two hooks blocking
the covers.
Release the cover rear corner
from the hooks by gently
squeezing the cover.
Pull out the cover rear corner
from the machine frame.
Pull out the cover upper corner
from the machine frame.
Make sure all the necessary
parts are prepared.
Pull the fan cable through
the side cover mounting hole.
Take out the filament roll from the plastic
bag and slide it on the bar. Put the bar with
filament on the holders.
Loosen the screws to the
point where you can slide the
spool holder.
Slide the spool holder in
place.
Tighten the screws.
