ZSPM4521
Evaluation Kit Manual
Kit Description
February 12, 2013
© 2013 Zentrum Mikroelektronik Dresden AG
— Rev. 1.00
All rights reserved. The material contained herein may not be reproduced, adapted, merged, translated, stored, or used without the
prior written consent of the copyright owner. The information furnished in this publication is
subject to changes without notice.
13 of 18
Important: After changing the configuration of the registers as needed, the values entered will take effect
immediately, but values will not be stored in the EEPROM. The values will be lost after a power cycle. In order to
write the configuration to the EEPROM, click the
“Write Config to EEPROM” button to write the new values to
ZSPM4521
’s EEPROM configuration registers.
The GUI
provides the “Save to File” button for saving the current configuration to a file, so that the user has the
option to load the file in the future
using the “Load From File” button.
Figure 9.5 Buttons for Saving Current Configuration Settings or Loading Previously Saved Configurations
9.3.
Reference Section
The right panel of the GUI provides a reference from the datasheet showing the definitions for register bits.
By default, the Status register definitions are shown as illustrated in Figure 9.1.
When access to the configuration registers has been enabled (see section 9.2),
the “Reference” section provides
defined values for configuration options for the register selected in
the “Configuration” section.
Figure 9.6 Using the Reference Section in Conjunction with the Configuration Section
Reference
Section
(Changes to
the register
selected)
Configuration
Section
3. Click on the row of the
register to be revised.
4. Refer to the data sheet definitions for the
register bits in the selected row and enter the
new hexadecimal value in the “data” column.
1. Click here if needed to display
“Disable Configuration Registers”
(enables writing to configurable
registers).
2.
Then click “Read Config.”
