ZK-D4330 (TP Version) User Manual
Copyright©2021 ZKTECO CO., LTD. All rights reserved.
P a g e
|
11
3.4
Installation Steps
Make sure that the device is installed as per the following installation instructions. If you
want to open the chassis, you should contact the agent for permission. Otherwise, you will
bear any consequence resulting from your actions.
After reading the precautions and checking the packing list, please follow the steps below
for installation.
Step 1:
Open the package, and then place the left and right door panels on the ground in
the direction shown in the figure 3-1 below. Pay attention to distinguish the left, right and
direction of the door panel (the signal line interface faces upward and inward).
Figure 3-1
Step 2:
Connect the rear beam with the left and right door panels with bolts, as shown in
the figure 3-2 below (note that the bolts are not tightened at this time).
