TS5000A Quick Start Guide 1
Chapter 1 Preparing
1.
Tools: a measuring tape, an adjustable wrench, an impact drill and a small screwdriver (included in the box).
2.
Material: a PVC anti-fire and insulation tube (diameter≥25mm), standard three-core power extension wire,
M12 expansion screw (included in the box).
3.
Thread the connection wire of the device through the tube before assembly.
4.
The power and signal wires should be set separately to easily distinguish strong and weak power. Please invite
a professional personnel to complete the wiring. The device must be connected to the ground.
Chapter 2 Fixing and Testing
1.
Mark all anchor holes on the floor and drill holes accordingly, then insert the expansion screw into the holes.
2.
Pre-fixe the device with these expansion screws.
3.
Test the operations of the device after connecting it to the power supply with the temporary cable. Make sure
that the ground wire of AC power is connected to the body of the device.
4.
Turn on the air switch and wait for 10 seconds for self-testing of the device. At the same time, check if the
indicators work properly. If everything works fine, fasten the screws and fix the device.
Installation diagram
