3
Notes:
1.
When installing the tripod turnstile against the wall, please reserve at least 100 mm space in order to open the cover
for adjustment and maintenance.
2.
The space at the end of the arm shall not be greater than 80 mm (see Figure 3-1).
3.
Setting a warning line for card swiping (see Figure 3-2). A warning line is suggested to prompt users to swipe cards in a
distance, which would greatly reduce the probability of equipment failure caused by improper operations.
Figure 3-2
3.2 Cabling
As shown in Figure 3-3, the unit is millimeter. Power supply and communication wire should be deployed underground
then into the cabinet of device. Cable protection covers are suggested to use if it is surface mounted.
Warning
: The tripod turnstile must be connected to the ground (earth), there is wiring interface near the power switch.
Figure 3-3
3.3 Installation
1.
Drilling holes.
Drill holes based on the locations of the holes shown in Figure 3-3.
2.
Fix the mounting plate to its original position.
Placing two mounting plates properly and apply screw securing glue on the surface and the threads of the expansion
bolts, install four expansion bolts to secure two mounting plates and use a horizontal ruler to make two mounting
plates on the same horizontal plane. If the mounting plate is not level, adjust it by the gaskets provided. Note that all the
four expansion bolts must be installed properly, and two expansion bolts on each mounting plate.
3.
Put the turnstile on two mounting plates and tighten the screws on the bottom of column, as shown in Figure 3-4.
Adjust the direction of the turnstile, as shown in Figure 3-5.
Figure 3-4 Figure 3-5
Installation levelness
Installation levelness
