Safety Instructions 1
1
Safety Instructions
1.1
Important Security Instructions
1)
Read, follow and keep instructions: Before operating the equipment, read and follow strictly all security and
operation instructions. Please keep the instructions in good condition for future reference.
2)
Accessories: Please use the accessories recommended by the manufacturer or delivered with the product. Any
other related product is not recommended as the major alarming or monitoring system. The major alarming
or monitoring system should comply with the local applicable fire-prevention and security standards.
3)
Installation cautions: Do not place this equipment on any unstable table, tripod mount, support or base, lest
the equipment should fall and get damaged, and more undesirably cause severe personal injuries. Therefore,
it is important to install the equipment as instructed by the manufacturer.
4)
All peripheral devices must be grounded.
5)
No external connection wires can be exposed. All connections and idle wire ends must be wrapped with
insulating tapes to prevent accidental contact with exposed wires from damaging the equipment.
6)
Repair: Do not attempt unauthorized repair of the equipment. Disassembly or detachment is likely to cause
shock or other risks. All repair jobs should be done by qualified repair personnel.
7)
Damages in need of repair: In any of the following cases, first disconnect the power supply from the
equipment and notify qualified repair personnel for repairs:
The power cord or connector is damaged;
There is entry of liquid or any other foreign object into the equipment;
The equipment is wetted or exposed to bad weather (rain, snow, etc.);
If the equipment cannot work normally even though operated as instructed, please be sure to adjust
only the control components specified in the operation instructions. Incorrect adjustment of other
control components may cause damage to the equipment, and even the equipment may not be
recovered;
The equipment falls down or its performance changes obviously.
8)
Replacing components: If it is necessary to replace a component, the repair personnel must use only the
substitutes specified by the manufacturer.
9)
Security inspection: After the equipment is repaired, the repair personnel are supposed to conduct security
inspection to ensure the equipment can work normally.
10)
Power supply: Operate the equipment with only the type of power supply indicated on the label. Contact the
operator for any uncertainty about the type of power supply.