16
InBio Pro and ZKBioSecurity 3.0 Quick Start Guide
Switching Dry Contact to Wet Contact
Important Notes:
The factory default jumper setting is set as dry mode. If you want to power the lock
from the panel, you must take the following steps:
1.
Take apart the cover of InBio460Pro. Push the tab inward (see figure 21).
2.
Select the appropriate lock relay and find its jumpers.
3.
Take off the jumpers and change
to
4.
Connect the lock as show in the diagram, (see figure 23 and 24).
Back of InBio460Pro
Select one Relay
Default setting
1, 2 - 3, 4
Take off jumpers
Jumpers
Plug Jumpers
2, 3 - 4, 5
Figure 21
Figure 20
Lock Connection
