Ziton ZP2-AF2-P, Installation Manual

Page: 59 / 176

Chapter 3: Configuration and commissioning
ZP2-A Series Installation Manual 53
The Panel setup menu
Use the Panel setup menu to set the date and time, to synchronize the date and
time in a fire network, and to set day or night mode sensitivity settings.
Date and time
Select Date and time to change the control panel date and time.
Note: Additional date and time settings (daylight saving, SNTP polling, etc.) are
available. See “Auto date and time” on page 97.
To change the date and time:
1. Select Panel setup from the Main menu.
2. Select Date and time.
3. Enter the date using the format DD/MM/YY (for example, 10/06/09).
4. Enter the time using the format hh:mm:ss (for example, 15:03:25).
5. If required, select YES for Firenet time sync to synchronize the date and time
across all control panels in a fire network.
6. Press F4 (Enter), and then press F1 (Back).
7. Press F2 (Exit) to exit the menu.
Day/Night mode sensitivity settings
Select Day/Night mode to change selected day/night fire detection and response
criteria based on preconfigured time settings, as shown below.
Note: This option is not available on repeater panels.
Table 22: Day/night mode settings and icons
Mode
LCD icon Description
Day
In this mode an automatic fire alarm (an alarm activated by a
detector) activates sounders and fire routing (if enabled) after
any configured delay. Subject to configuration, detectors may
use a reduced sensitivity setting.
Night In this mode an automatic fire alarm (an alarm activated by a
detector) activates sounders and fire routing (if enabled)
immediately and bypasses any configured delay. Subject to
configuration, detectors may use an increased sensitivity setting.
The LCD icon confirming the current mode is displayed on the LCD and indicates
whether the setting applies only to the local control panel or is a general setting
for all control panels in the fire network. For more information on LCD indications,
see “LCD controls and indicators” on page 12.