ZP2-A Series Operation Manual
21
Operation controls and procedures
Using the function buttons and the jog dial
Use function buttons F1 to F4 and the jog dial (see Figure 3 on page 11) to
navigate the LCD menus, to select menu options, and to enter passwords and
system information, as shown below.
Entering passwords and
system information
Turn the jog dial clockwise or anticlockwise to enter passwords
and other system information. Press the jog dial to confirm an
entry.
Selecting soft keys from the
LCD menu
Press the function buttons F1 to F4 to select the corresponding
menu options (Main menu, Logout, Exit, etc.).
Navigating and confirming
menu selections
Turn the jog dial clockwise or anticlockwise to select an option
from the on-screen menu. Press the jog dial to confirm the
selection.
The control panel ID on the LCD is white text with a dark background when the
jog dial is active (the control panel is waiting for input).
Configuration options
The options listed below are available when making configuration changes to the
control panel (for example, changing the password).
The control panel configuration (and configuration revision) is only updated when
configuration changes are applied by pressing F3 (Apply).
The configuration revision change and timestamp are recorded in the Revision
report and can be accessed at operator level (see “Viewing reports” on page 28).
Table 10: Configuration control options and keys
Option
Key
Description
Save
F1
Saves the current configuration change without applying it immediately.
Apply
F3
Applies the current configuration change and all stored (saved)
configuration changes. The control panel will reset automatically.
Discard
F4
Discards all stored (saved) configuration changes that have not been
applied.
Exit
F2
Exits the configuration process without storing or applying the current
configuration change.
Note:
When updating multiple configuration settings, we recommend that you
save after each change and then apply all changes from the Main menu.
