Ziton ZP1-X3E Series, Installation Manual, Page: 39 / 114

Chapter 3: Configuration and commissioning
ZP1-X3E Series Installation Manual 33
Basic default configuration
Use this menu to select operating mode configuration presets.
In both basic standard and basic evacuation modes, zone detection is the same.
The extinguishing area uses Z1 and Z2 (automatic). Fire detection uses Z3
(mixed).
Available presets are shown in the table below. The default setting is 01 (Basic
standard mode, passive end-of-line).
Table 14: Operating mode configuration presets
Display
Mode Zone configuration Manual fire
sounder start
Actuator delay
for MCP Start
01 (default) Basic standard Passive end-of-line No Yes
02 Basic standard Passive end-of-line,
CleanMe enabled
No Yes
05 Basic evacuation Passive end-of-line Yes (operator
user level) [1]
No (bypassed)
06 Basic evacuation Passive end-of-line,
CleanMe enabled
Yes (operator
user level) [1]
No (bypassed)
11 BS 7273 stage 1 Active EOL No Yes
12 BS 7273 stage 2 Active EOL No Yes
61 Repeater with fire
routing (EN 54-2)
N/A N/A N/A
63 Repeater with fire
routing (BS 7273)
N/A N/A N/A
00 Custom [2] N/A N/A N/A
[1] A fire alarm is not required to activate the fire sounders.
[2] This option cannot be selected. It is displayed automatically when an advanced configuration
is entered
To change the operation mode configuration preset:
1. Set the display as shown below, and then press Enter.
2. Select a value using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your changes.