Ziton ZP1-X3E Series, Installation Manual, Page: 20 / 114

Chapter 2: Installation
14 ZP1-X3E Series Installation Manual
Here are the operating details of the function.
When the panel is not in extinguishing activation or extinguishing released states:
• For manual-automatic mode, the panel reports a fault if the door is open and
the door fault delay expires
• For manual-only mode, the panel reports a fault if the door is closed and the
door fault delay expires
When the system is in extinguishing activation or extinguishing released states,
no matter which operating mode, the panel reports a fault if the door is open.
Connecting a remote reset device
The remote reset input allows the control panel to be reset from a remote
location. The reset operation is the same as using the Reset button on the
control panel user interface.
Note: EU ordinances and regulations require the use of a key switch to control
access to this function.
The remote reset is executed when the input device switches from deactivated to
activated. See “Input and output specifications” on page 83 for the impedance
values for this unsupervised input.
Connecting outputs
Output functionality
Each control panel has eight outputs, marked OUT1 to OUT8 on the control
panel PCB. Output functionality is shown in Table 8 below.
Table 8: Output functionality
Output Function
Type and status
OUT1 Hold extinguishing manual call point Free-of-voltage (unsupervised switch)
Hold inactive = open
Hold active = closed
OUT2 Abort extinguishing manual call point
Disable extinguishing switch
(BS 7273 mode)
Free-of-voltage (unsupervised switch)
Abort inactive = open
Abort active = closed
Free-of-voltage (unsupervised switch)
Enabled = open
Disabled = closed
OUT3 Manual-only mode Free-of-voltage (unsupervised switch)
Manual-automatic = open
Manual-only = closed