Ziton ZP1-X3E Series, Installation Manual, Page: 12 / 114

Chapter 2: Installation
6 ZP1-X3E Series Installation Manual
Fixing the cabinet to the wall
Fix the cabinet to the wall using five M4 × 30 screws and five 6 mm diameter wall
plugs, as shown below.
Figure 2: Mounting hole locations
To fix the control panel cabinet to the wall:
1. Mark drill points on the wall, using the cabinet as a template.
2. Drill all required holes and insert a 6 mm wall plug into each.
3. Insert a screw in position (1) and hang the cabinet onto this screw.
4. Insert screws in positions (2) and tighten.
5. Insert screws in position (3) and tighten.
6. Tighten screw in position (1).