Ziton ZP1-X3E Series, Installation Manual, Page: 64 / 114

Chapter 3: Configuration and commissioning
58 ZP1-X3E Series Installation Manual
Zone delay
Use this menu to configure zone delays, on or off, for each zone in your fire
alarm system. The default setting is On.
To configure the zone delay:
1. Set the display as shown below, and then press Enter.
2. Select the zone (for example, zone 1), and then press Enter.
The Zone alarm LED flashes fast to indicate that the corresponding zone
configuration menu is active.
3. Select a value using the value selection buttons (2 and 4).
4. Press Enter.
5. Save your changes.
The available settings for this feature are shown below.
Display Description
Configured delays are allowed in the corresponding
zone.
Configured delays are not allowed in the corresponding
zone
Zone type
Use this menu to configure the zone type for each zone in your system.
To configure the zone type:
1. Set the display as shown below, and then press Enter.
2. Select the zone (for example, zone 1), and then press Enter.
The Zone alarm LED flashes fast to indicate that the corresponding zone
configuration menu is active.
3. Select a value using the value selection buttons (2 and 4).