Ziton ZP1-X3E Series, Installation Manual, Page: 62 / 114

Chapter 3: Configuration and commissioning
56 ZP1-X3E Series Installation Manual
The available settings for this feature are shown below.
Display Description
The earth fault check is enabled.
The earth fault check is disabled.
Fault latch
Use this menu to configure the fault latch, on or off. This determines whether the
power supply fault is latched or not. The default setting is On.
To configure the fault latch:
1. Set the display as shown below, and then press Enter.
The general fault LED flashes fast to indicate that the fault latch menu is
active.
2. Select a value using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your change
The available settings for this feature are shown below.
Display Description
The fault latch is enabled.
The fault latch is disabled.