Ziton ZP1-X3E Series, Installation Manual, Page: 49 / 114

Chapter 3: Configuration and commissioning
ZP1-X3E Series Installation Manual 43
Display Menu Values
Restore previous configuration N/A
Restore factory configuration N/A
Exit without saving N/A
Exit and save N/A
Note: See “Basic configuration” on page 31 for details on the settings available in
basic configuration: Panel mode, Actuator delay, Reset disabled delay, Fire
sounders delay, and Fire routing delay. The default values defined above are for
the Basic standard mode.
Safety door monitoring
Use this menu to configure safety door monitoring, on or off. The default setting
is OF.
For a description of the safety door monitoring function, see “Connecting a safety
door fault monitoring device” on page 13.
To configure safety door monitoring:
1. Set the display as shown below, and then press Enter.
The Door Fault LED flashes fast to indicate that the configuration menu is
active.
2. Select a value using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your changes.
The available settings for this feature are shown below.
Display Description
Safety door monitoring is used (on).
Safety door monitoring is not used (off).