Ziton ZP1-X3, Installation Manual, Page: 29 / 88

Chapter 3: Configuration and commissioning
ZP1-X3 Installation Manual 23
The user interface
Figure 13: The user interface
1. Zone buttons and LEDs (Z1, Z2, Z3)
2. Supply LED
3. General Fault LED
4. General Fire Alarm LEDs
5. Preactivation button and LEDs
6. Released LEDs
7. Extinguishing Sounders On button and
LEDs
8. Fire Sounders Delay button and LEDs
9. Optical Panel On LEDs
10. Door Fault/Disabled LED
11. Networking Fault LED
12. Reserved for future use
13. Expansion I/O Fault/Disabled LED
14. General Disable button and LED
15. General Test button and LED
16. Low Pressure LEDs
17. Extinguishing Agent Flow LEDs
18. Reset button and LED
19. Panel Silence button and LED
20. Fire Sounders Start/Stop button and LED
21. Numeric keypad and Enter button
22. Manual Mode button and LED
23. System Fault LED
24. Out of Service LED
25. Earth Fault LED
26. Supply Fault LED
27. MCP Abort LEDs
28. MCP Hold LEDs
29. MCP Start LEDs
30. Fire Routing Delay button and LED [1]
31. Fire Routing On button and LEDs [1]
[1] Fire routing is only available if a 2010-1-SB board is installed and a fire routing command is
configured.