Ziton ZP1-F2, Installation Manual

Page: 13 / 113

Chapter 2: Installation
ZP1-F Series Installation Manual 7
Fixing the cabinet to the wall
The requirements for nylon wall plugs and screws are shown in the following
table.
Model Screws Wall plugs
Two- and four-zone control
panels
M4 × 30 (4X) Ø 6 mm (4X)
Eight-zone control panel M4 × 30 (5X) Ø 6 mm (5X)
Figure 3: Mounting hole locations
To fix the control panel cabinet to the wall:
1. Mark drill points on the wall, using the cabinet as a template.
2. Drill all required holes and insert a 6 mm wall plug into each.
3. Insert screw (1) half way and hang the cabinet onto this screw.
4. Insert screws (2) and tighten.
5. Insert screws (3) and tighten.
6. Tighten screw (1).