ASSEMBLY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
28
ZI-STB16T
12.3
Assembly
Place the column
tube on the
baseplate. Bolt the
column tube to the
baseplate with the
four screws M8×20
supplied. Tighten
the screws
moderately tight
with an open end
wrench SW 13 (not
scope of delivery) so
that the threads in
the baseplate do not
strip.
Place the drilling bench
holder over the rack. The
teeth of track must mesh
with the teeth of gear.
(see figure 1).
Slide the drilling bench
on the column tube.
Make sure the bottom
bevel of rack insert into
the bottom disc of the
column tube. (see fig. 2)
Slide the collar over
the column tube
with beveled edge
facing down until it
presses against the
top of the rack. (see
fig. 3)
Tight the set screw,
but do not
overtighten it. (see
fig. 4)
Slide the height crank
over the shaft on the
side of drilling bench.
(see fig. 5)
Secure the height crank
to the shaft using allen
key 3mm. (see fig. 6)
Place the machine
head on the column
tube and secure the
machine head with
the two grub screws
tot he side with the
allen key 4mm.
Put the drill chuck guard
on the upper part oft he
drill spindle. Secure the
drill chuck guard with a
screwdriver.
Fold the drill chuck
guard upwards.
Insert the drill
chuck on the taper
of the drill spindle.
Push the drill chuck
onto the drill spindle
with a few light
tabs. Use a plastic
hammer for this
purpose.
Bolt the three drill lifting
arms into the hand
spindle guide and fix
them.
Bohrspindel