SAFETY
24
ZI-RBMA1500
12.3
Safety devices
The machine is equipped with the following safety devices:
With the emergency stop switch dangerous movements can be stopped at any
time.
The motor protection switch (1) interrupts the power supply in case of an overvolt-
age in the power supply system.
12.4
General safety instructions
To avoid malfunctions, damage and health impairments when working with the machine, the following
points must be observed in addition to the general rules for safe working:
•
Check the machine for completeness and function before starting. Only use the machine if the
separating and other non-separating protective devices required for machining have are fitted.
•
Make sure that the guards are in good working order and properly maintained.
•
Select a level, vibration-free surface as the installation area.
•
Ensure sufficient space around the machine!
•
Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects.
•
Ensure a clean working environment.
•
Keep the area around the machine free of obstacles (e.g. workpiece parts, etc.).
•
Only use tools that are in perfect condition and free of cracks and other defects (e.g. defor-
mations).
•
Remove tool keys and other setting tools before switching on the machine.
•
Check the machine's connections for strength before each use.
•
Never leave the running machine unattended. Switch off the machine before leaving the work-
ing area and secure it against unintentional or unauthorized restarting.
•
The machine may only be operated, maintained or repaired by persons who are familiar and
who have been informed about the dangers arising from this work.
•
Ensure that unauthorized persons keep a safety distance from the machine and keep children
away from the machine.
•
Always work with care and the necessary caution and never use excessive force.
•
Do not overload the machine!
•
Hide long hair under hair protection.
•
Wear suitable protective equipment (eye protection)!
•
Never wear loose jewellery, loose clothing or accessories (e.g. tie, scarf).
•
Do not work on the machine if you are tired, not concentrated or under the influence of medi-
cation, alcohol or drugs!
•
Shut down the machine and disconnect it from the power supply, before adjustment, change-
over, cleaning, maintenance or repair work, etc. Before starting work on the machine, wait until
all tools or machine parts have come to a complete standstill and secure the machine against
unintentional restart.
•
Warning signs and/or stickers on the machine that are illegible or have been removed must be
replaced immediately!
12.5
Electrical safety
•
Make sure that the machine is grounded.
•
Only use suitable extension cables.
•
A damaged or tangled cable increases the risk of electric shock. Handle the cable with care.
Never use the cable to carry, pull or disconnect the power tool. Keep the cable away from heat,
oil, sharp edges or moving parts.
•
Proper plugs and outlets reduce the risk of electric shock.
•
Water entry into the machine increases the risk of electric shock. Do not expose the machine to
rain or moisture.
•
The machine may only be used if the power supply is protected by a residual current circuit
breaker.
