OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
34
ZI-MD500HS
15.3.2
Check oil level
Place machine on a level ground
Remove oil cap
Wipe oil from the dipstick
Replace the dipstick without tightening the oil cap!
Pull out the dipstick again.
Check the oil level. Oil level must be between min and max
Fill in oil if low level
15.3.3
Fill hydraulic oil
In the hydraulic oil tank on the top right is approximately 3,5 liters of hydraulic oil -eg
HL 46- or similar filled.
15.3.4
Refuel
W A R N I N G
Use only unleaded fuel with min. 95 octane or higher
Never use 2-stroke mixture of diesel! DAMAGE OF ENGINE!
Refuelling only outdoors!
Before removing the filler cap, turn the
engine off and let it cool machine
Clean the fuel filler cap area
Remove the filler cap carefully
Fill in fuel
Fuel tank capacity: 6 l. Fill tank only up
to 1,5 cm below the rim of the filler
neck, so that the fuel has place for
expansion.
Replace and tighten the filler cap
Wipe any fuel residues and wait until it
evaporates
Summary of Contents for ZI-MD500HS
