OPERATION
40
ZI-KGS210DS
15.2.5
Connection to a dust collection system
For dust extraction in closed rooms, connect a suction hose to the dust extraction nozzle and fix it with a
hose clamp. Connection dimensions according to technical data.
15.2.6
Switch machine ON-OFF
•
Switch the machine ON:
Press the locking button (1) and then press and hold
the ON-OFF switch (2) on the handle.
•
Switch the machine OFF:
Release the ON-OFF switch (2)
15.2.7
Setting the speed
Set the speed-selector switch to the desired speed:
•
Pos I: 3200 min
-1
•
Pos II 4500 min
-1
15.2.8
Switch Laser ON-OFF
•
Switch the laser on/off with switch (1).
•
The laser indicates the exact cutting line on the
workpiece.
15.3
Operation modes
15.3.1
Mitre cuts
Mitre are particularly suitable for cutting small workpieces (approx. 100 mm) to length.
•
For mitre cuts, the sliding mechanism is fixed in the rear
position by the drag lock (1) so that the machine head
cannot slide forwards or backwards during the cut.
•
Adjust the angle setting according to the desired
operation and adjust the fences accordingly.
•
Mark the cutting line (by laser).
•
Place the workpiece against the fence and table and fix it
with the clamp device (2).
•
Move the machine head to its uppermost position.
•
Switch on the machine and wait until the saw blade has
reached full speed.
•
Make the mitre cut (move the machine head downwards)
until it has reached the lowest position.
•
Move the machine head to the uppermost position.
N OTE
Machine head is spring loaded, do not simply
release the machine head, instead move the
handle upwards until the uppermost position is
reached (rest position).
•
Release the ON-OFF switch and wait until saw blade
comes to stand still.
•
Remove workpiece.