ASSEMBLY
36
ZI-KGS210DS
N OTE
Deviation of the supply voltage and frequency!
A deviation from the value of the supply voltage of ±5 % is permissible.
A short-circuit fuse must be provided in the power supply system of the machine!
•
•
Use a supply cable of type H07RN (WDE282) or take the required cross-section of the supply
cable from a current carrying capacity table. Pay attention to the measures for protection
against mechanical damage.
•
Make sure that the power source is protected by a residual current circuit breaker.
•
Connect the device only to a properly grounded outlet.
•
When using an extension cable, make sure that the dimension matches the connected load of
the machine. The connection power can be found in the technical data, the correlation of cable
cross-section and cable lengths can be found in the technical literature or obtain information
from a specialist electrician.
•
A damaged cable must be replaced immediately.
14.4
Settings
14.4.1
Fine adjustment fence
•
Press the machine head downwards and fix it by
inserting the locking bolt (1).
•
Fix the rotary table in the 0°-position with the mitre lock
(2).
•
Place a 90° stop angle (3) on the saw blade (4) and
against the fence (5).
•
Loosen the screws (6) at both sides with an Allen key and
align the fence at an angle of 90° to the saw blade.
•
After adjustment, retighten the screws (6).
•