ASSEMBLY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
36
ZI-HAEK15000
5.
Connection safety switch
•
Connect the two plugs of the safety switch
(2) to the one on the motor (1).
NOTE:
Thread the cable of the safety switch
(stop bar) through the bore hole at dis-
charge chute of the machine. (The battery
cable runs through the same holes (A)).
6.
Connecting the battery
•
Make or check the battery connection (+)
pole (-) pole as illustrated on the left.
•
First connect the (+) pole to the battery and
then the (-) pole (= mass cable).
14.3
Checklist before each use
N OTE
The use of paint thinners, petrol, aggressive chemicals or abrasives leads to material damage to the
surfaces! Therefore use only mild detergents for cleaning!
•
Clean the machine and remove dirt and dust if necessary.
•
If the air filter is dirty, blow the filter cartridge from the inside by moving a jet of dry com-
pressed air up and down. Continue until all dust has been removed. Replace the air filter with a
new one if necessary.
