SAFETY
17
ZI-ET260
11.3
General safety instructions
To avoid malfunctions, damage and health impairments when working with the machine, the following
points must be observed in addition to the general rules for safe working:
•
Check the machine for completeness and function before starting. Only use the machine if the
separating and other non-separating protective devices required for machining have are fitted.
•
Ensure sufficient lighting conditions at the workplace to ensure safe handling of the machine.
•
Remove tool keys and other setting tools before switching on the machine.
•
Check the machine's connections for strength before each use.
•
Never leave the running machine unattended. Switch off the machine before leaving the working
area and secure it against unintentional or unauthorized restarting.
•
The machine may only be operated, maintained or repaired by persons who are familiar and who
have been informed about the dangers arising from this work.
•
Ensure that unauthorized persons keep a safety distance from the machine and keep children
away from the machine.
•
Wear suitable work clothing and footwear.
•
Always work with care and the necessary caution and never use excessive force.
•
Shut down the machine and disconnect it from the power supply, before adjustment, changeover,
cleaning, maintenance or repair work, etc. Before starting work on the machine, wait until all tools
or machine parts have come to a complete standstill and secure the machine against uninten-
tional restart.
•
Do not work on the machine if you are tired, not concentrated or under the influence of medica-
tion, alcohol or drugs!
11.4
Special safety instructions for this machine
•
Caution in slippery conditions - slip hazard - risk of injury. When working, robust and non-slip foot-
wear. Slides / stumble / traps are a major cause of serious injury or death.
•
Never use the machine when it is raining or in damp, wet areas.
•
Always use both hands to hold the machine when in use.
•
Before start, after failure or shock, be sure to check the machine and make sure that it is in good
condition.
•
Unplug battery before all maintenance and settings!
CHARGER
:
•
The charger is designed exclusively to charge the battery of this machine. Charging other batteries
is not permitted.
•
Never use the charger in a damp or wet environment.
•
Disconnect cable connections only by pulling the plug. Pulling on the cable could damage the
cable and plug and electrical safety would no longer be guaranteed.
•
Never use the charger if the cable, plug or the machine itself are damaged by external influences.
Then take the charger to the nearest specialist workshop.
•
Do not operate the machine in close proximity to heat sources.
•
Do not use an extension cord to plug in the charging station's power supply.
•
Do not place any metal objects in the area of the charging contacts of the charger.
•
Do not open the charger. In case of failure, contact a specialist workshop.
•
Only use the original charger to charge the battery. If other chargers are used, defects may occur
or a fire might be caused.
BATTERY:
•
Vapours may be emitted during improper use or when using damaged batteries. These vapours
can irritate the respiratory tract. Inhale fresh air and consult a physician if you experience any dis-
comfort.
•
EXPLOSION HAZARD! Protect the battery from heat and fire.
•
Only use the battery in an ambient temperature between 0° C and +45° C.
•
HAZARD OF SHORT-CIRCUIT! For disposal, transport or storage, the battery must be packed (plas-
tic bag, box) or the contacts must be taped.
•
Never open the battery.
