ZIPPER MASCHINEN ZI-STM350C, User Manual

Page: 18 / 49

OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at  18
ZI-STM350C
14 OPERATION
General:
All modifications has to be performed with machine being switched off.
 Check (6), (11), (12) and (1) for tightness
Water flow valve open.
 Turn on the machine by pressing the green ON button (13 - side of the saw unit) a.
 Wait until the diamond blade at full speed, and the sheet is cooled with water.
 Sections perform.
 Switch the machine off with red OFF button (13) again
Cuts:
You can perform different cuts by adjusting the depth stop (11) and height stop (12).
Straight cut
 Adjust depth stop (11) so, that the diamond blade reaches approx. 5mm below the sliding
table surface. Hold the sawing aggregate with one hand in this position and adjust the
height stop (12) to this height position as well.
 Now you can cut the material by feeding the material to the diamond blade.
Chop cut
 For short workpieces you can use the chop cut
 Keep the (11) position, and release the (12) stop up to wor 1cm height
 Do not place your hands near the blade
 Always align the material to cross and parallel fence.
Adjust cutting angle
 You can perform cuts from 90°-45°
 Loosen the angle fixing lever (6)
 Swing the entire cutting aggregate until you have reached the desired angle.
 Tighten the angle fixing lever back again (6).