ASSEMBLY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
28
ZI-STE1800IV
17
ASSEMBLY
Checking scope of delivery
Check the machine immediately after delivery for transport damage and missing parts. Report
any damage or missing parts immediately to your dealer or the forwarder. Visible transport
damage must also be noted immediately on the delivery note in accordance with the warranty
provisions, otherwise the goods will be deemed to have been properly accepted.
Checklist before each use
N O T I C E
Always place the machine on a firm and flat surface! No turning, tilting or moving
during the engine is running
Always check oil and fuel level before starting
Do not connect the appliance before the unit is running at full speed. Disconnect
the appliance before turning the unit off.
Connected devices must be in perfect condition.
Keep the cable length to the consumer as short as possible.
17.2.1
Checking the engine oil level
N O T I C E
A too low oil level will damage the engine and shorten the life of the machine.
Therefore, check the engine oil level before every start and top up the engine oil if
necessary.
N O T I C E
The low oil warning system will turn off the engine before the oil level descends to
the security line. But to avoid the inconvenience caused by unexpected machine halt,
we advise you to check the oil level regularly.
1.
To check the engine oil level, place the machine on a
safe, level surface.
2.
Switch off the engine and allow the machine to stand
for ten minutes so that the circulating oil can collect in
the oil pan.
3.
Unscrew the screws (1) and remove the side cover (2).
4.
Unscrew the screw cap (3) with the oil dipstick and
wipe with a clean, lint-free cloth or a non-fibrous paper
towel.
5.
Push the dipstick into the opening, but do not screw it
in. (Make sure that the dipstick has really been pushed
in completely).
6.
Pull out the oil dipstick again and read off the oil level.
There are two markings for this:
L = min. oil level
H = max. oil level