SAFETY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
21
ZI-EWB500LI
11
SAFETY
This section contains information and important notes on the safe commissioning and handling of the
machine.
For your safety, read this manual carefully before commissioning. This will enable you to handle
the machine safely and thus prevent misunderstandings as well as personal injury and
damage to property. Pay special attention to the symbols and pictograms used on the
machine as well as the safety information and danger warnings!
11.1
Intended use of the machine
The machine is designed exclusively for the following activities:
Transportation of gods within the maximum
permissiable load capacity.
11.1.1
Technical Restrictions
The machine is designed for the work under the following conditions:
Relative humidity:
max. 65 %
Temperature (for operation)
+5° C to +40° C
The machine, especially the battery; may not be exposed to a temperature of about 80 °C. Do not store in
the blazing sun or a long time in the trunk of a car.
11.1.2
Prohibited applications / Dangerous misuse
•
Operating the machine without adequate physical and mental fitness.
•
Operating the machine without knowledge of the manual.
•
Modifying the machine design.
•
Operating the machine in wet and rainy conditions.
•
Operating the machine outside the technical limits specified in this manual.
•
Removing of the safety markings attached to the machine.
•
Modifying, circumventing or disabling the safety devices of the machine.
The non-intended use or the disregard of the explanations and instructions described in this manual will
result in the expiration of all warranty claims and compensation claims for damages against ZIPPER
MASCHINEN GmbH.
11.2
User Requirements
The machine is designed to be operated by one person. The prerequisites for operating the machine are
physical and mental fitness as well as knowledge and understanding of the operating instructions. Persons
who, due to their physical, sensory or mental capabilities, inexperience or lack of knowledge, are unable to
operate the machine safely must not use the machine without supervision or instruction by a responsible
person.
Basic knowledge of metalworking especially the correlation of material, tool, feed and speeds.
Please note that locally applicable laws and regulations determine the minimum age of the operator and
may restrict the use of this machine!
Put on your personal protective equipment before working on the machine.
Work on electrical components or equipment may only be carried out by a qualified electrician or under the
guidance and supervision of a qualified electrician.
N OTE
ZIPPER MASCHINEN GmbH assumes no responsibility or warranty for any other use or use
beyond this and for any resulting damage to property or injury.
