R I V E T T / R O C K E T T
49
Be sure that rear edge of deck is glued.
Carb hatch in deck.
Deck Access Hatch
The deck must have an access hatch for the
carb.
You will have to cut this hatch based on the
location of your engine. The hatch should
measure about 3-1/4 by 1-1/4 inches.
Carefully measure and mark the position of
the hatch directly on the deck.
Use a fine tooth razor saw to cut out the
hatch. Cut through the deck supports.
Do a neat job here.
When the hatch is cut out, sand the edges of
the hatch and opening, to allow for the paint
thickness.
Summary of Contents for RIVETT
