R I V E T T / R O C K E T T
33
Interior sealed with epoxy.
Radio box and mounts.
Drilling mounting holes in radio box.
After you are 100% sure that all exposed
wood inside the hull has been coated, let it
sit overnight.
After the hull sealer has had a chance to
cure, let’s get the radio box mounted.
Radio Box Mounts
Grab the two radio box mounts. These are
¼ ply, about 3-3/4x3/4.
Mark a centerline along the length of both
mounts.
On one of the mounts, mark lines ¾ from
both ends.
On the other mount, mark the center.
Drill 3/16 holes at the intersections of your
lines.
Hold the rear mount on the bottom of the
radio box. This should be at the rear end of
the box (where the rudder servo is). Center
the mount side to side, and flush with the
rear.
While holding the mount, mark the two
holes onto the bottom of the radio box.
Do the same for the front mount, except
hold it lengthwise along the center of the
radio box, flush with the front and centered
side to side.
Summary of Contents for RIVETT
