R I V E T T / R O C K E T T
19
Tape, clamps and weights build a strong, straight
hull.
Sponson bottom sanded and ready for sheeting.
Bottom sheeting test fitted.
the frame.
Check that the non trip side in contact all
the way around.
When satisfied, put the hull on the building
board, and weight it down
Allow to cure at least 2 hours.
Repeat on other side
When the non trip sides have fully cured,
remove the tape and clamps.
Sponson Bottoms
Plane and sand the sides even with the
sponson bottom. Take your time here, as
this is a critical ride surface.
Make sure that you sand the sponson
bottom evenly and squarely.
Test fit the sponson bottom in place.
If all is well, lightly mark the inside of the
bottom.
Repeat on other sponson.
Place your ¾ inch thick gluing block on the
work surface. We don’t need the building
board for the next steps.
Summary of Contents for RIVETT
