R I V E T T / R O C K E T T
18
Ready for sponson side.
Sealing hard to reach areas while gluing.
Sponson side with epoxy.
surface for the non trip side. This is normal.
Mix up about ½ ounce of 30 minute epoxy.
Using your special epoxy brush, put a coat
of epoxy on the chines and bulkheads
where the sides will touch.
Also seal the chines at this time, as they
will be difficult to seal after the sides are in
place.
Brush epoxy on the outer perimeter of the
non trip side.
Make sure you apply epoxy to the correct
side of the correct part!
Use tape and clamps to hold side against
Summary of Contents for RIVETT
