R I V E T T / R O C K E T T
15
Sanding bulkhead 2 in preparation for the engine
rails.
Test fitting rails by “snapping” them into bulkhead
3.
Rails in place. Note cutout in right rail for carb.
Engine Rails
Lightly sand the vertical parts of bulkhead 2
for the engine rails.
The engine rails have round holes to
indicate the front. The right rail also has a
cutout for the carb.
Test fit the rails as follows:
Put the right rail in the slot in bulkhead 1.
Push the rail against bulkhead 3 so that it
“bows” back slightly. The rail will snap into
place. Do the same for the left rail. If all
looks good, carefully remove the rails by
bowing bulkhead 3 back so that you can
get them out, one at a time.
Mix up about ½ ounce of 30 minute epoxy.
Coat the bottoms of the rails, as well as the
slots in the bulkheads with epoxy. Coat the
drain holes at the rail slots.
Also coat the two vertical surfaces on
bulkhead 2.
Summary of Contents for RIVETT
