R I V E T T / R O C K E T T
8
Marking parts before removal.
Bulkhead 3 with turn fin doubler removed. Middle
piece gets tossed.
Incorrect doubler installation. Note bottom chine
slot is covered.
Let’s get started.
The first thing you should do is to carefully
sand the parts while they are still in the
sheets. Do this with your 80 grit sanding
block.
Sand both sides, as this will make it much
easier to sand the parts once they are out
of the sheet.
While the parts are still in their sheets, use
a pencil to mark each part with the name,
and which side is right or left, as the parts
only fit correctly one way.
Turn fin doubler
Sand the edges of bulkhead 3. Sand inside
the holes.
Remove the cutout containing the turn fin
doubler.
Remove and sand the doubler. Toss the
piece it was in.
The doubler only goes on correctly one
way.
Hold the doubler over the matching holes
on bulkhead 3. Make sure you are on the
FRONT RIGHT of the bulkhead. This will be
the forward facing side.
Summary of Contents for RIVETT
