E A S Y V E E
42
Stinger drive level with bottom.
Final assembly
Before you bolt anything to the hull, give it a good
coat of paste wax.
Put the boat on your stand. This is where it will live,
when it’s not in the water.
Sharpen the turn fin. Using a file and 220 grit paper,
sharpen both sides of the leading edge.
The front should be sharp, and the back flat.
Install the engine.
Install the servos.
Install the stinger drive.
Install the rudder assembly.
Install the sharpened and balanced prop and prop
nut on the flex shaft.
Install the fuel tank and fuel lines. Place foam
rubber under the tank, and use a few rubber bands
to hold the tank in place.
Install the bulkhead fittings and water outlet.
Install exhaust or tuned pipe.
Be sure pipe is fully supported at the end.
Install water lines.
Push the threaded end of the rudder and throttle