E A S Y V E E
31
Stinger drive mounted to transom.
Busy transom…
Rudder should protrude 1-1/2 to 2 inches below
keel.
Hardware:
Draw a line on the transom, from top corner to top
corner.
Mark the center of this line, and put a mark 2-1/2
inches to the right of the center line.
Hold the stinger assembly against the transom, slip
the cable through it, into the stuffing tube and mark
one hole location.
Drill the hole in the transom, and bolt the stinger
assembly on.
Check to see that the stinger is aligned side to side,
as well as not twisted. When satisfied, mark the
other three holes.
Drill the transom and install the three bolts and
nuts.
Set the radio box between the rails, about an inch
behind bulkhead 4. It should be sit snugly between
the rails, and touch the bottom.
Assemble the rudder to the brackets.
Mount it to the transom, aligning the rudder blade to
your reference line, 2-1/2 inches to the right of
center. Try to get at least 1-1/2 inches of the rudder
below the bottom of the boat.
Make sure the rudder is not slanted right or left.
Use a square on the top of the boat to sight the
rudder for square.
Be sure to consider where the rudder arm will be, in
relation to the servo arm when mounting the rudder.
Try to make it a straight line from the rudder servo
arm to the rudder arm.